What Is The Difference Between Side-emitting And Direct-emitting LED Lamp Beads

Jul 20, 2022

Leave a message

The side-emitting patch led backlight is a backlight made by placing a linear or point light source on the side of a specially designed light guide plate. The process of direct type backlight source is relatively simple and does not require a light guide plate. The light source (LED chip array) and PCB are placed at the bottom of the backlight source. After the light is emitted from the LED, it passes through the reflector at the bottom, and then passes through the diffuser plate on the surface to enhance brightness. The film is ejected uniformly.


Side-emitting LED lamp beads have low brightness, generally within 3000lm in 595*595 specifications;


It can be used in some occasions with low ceilings.


Thinner, the thickness is within 15mm.


The surface uniformity is poor, and the brightness uniformity is up to 0.85. If it is not handled well, there will be obvious bright edges around it.


The cleanliness of the workshop is required to be high, the process control is not good, and the yield rate is low (mainly due to dust causing bright spots in the light guide plate).


The finished side-emitting panel light uses the light guide plate technology to design the dots of the light guide plate according to the arrangement of the lamp beads of the LED lamp board and the light-emitting angle of the lamp beads, so that the light can pass through the light guide plate to achieve the effect of uniform brightness.


The backlight panel light is designed with a reasonable LED spacing by using the LED light-emitting angle, and with the diffuser plate and the height of the lamp to achieve the ideal light mixing effect.


Emphasis on high brightness, 595*595 specifications can reach 4000lm, high light efficiency products, replace the traditional grille light panel.


Thicker, usually more than 45mm thick.


The light output is relatively uniform, and the brightness uniformity can reach more than 0.9.


The process requirements are relatively simple.


When the side-emitting SMD LED backlight source is applied to medium and large-sized LCDs, the weight and cost of the light guide plate will increase with the increase in size, and the brightness and uniformity of the light emission are not ideal. At the same time, the side-emitting SMD LED backlight LCD TV is because The use of light guide plates cannot realize the regional dynamic control of LCD TVs, and can only achieve simple one-dimensional dimming, while the direct-type LED backlights perform better and can realize regional dynamic control of LCD TVs. The edge light type backlight can be made very thin, but the light utilization rate of the backlight source is small, and the thinner the light source, the smaller the utilization rate. The core of its technology is the design and production of the light guide plate. At present, there are mainly two types of printing type and injection molding type. In the form of light guide plate, others such as injection molding plus printing, laser dotting, corrosion, etc. account for a small proportion, which is not suitable for mass production principles. The advantages of the direct type backlight technology are high brightness, good light-emitting viewing angle, high light utilization efficiency, and simplified structure.


A certain space is reserved between the diffuser and the LED light source to improve the brightness uniformity. Therefore, the direct-lit backlight also increases the thickness, weight and power consumption of the module. Therefore, the number of light sources, luminous brightness and power consumption are greater than those of the side. Light type backlight.


Send Inquiry
Send Inquiry