How to use smart electric clothes drying rack

Dec 15, 2023

Leave a message

1. Preparations for installation of smart clothes drying rack
(1) Ensure that power cords are reserved at both ends of the installation location, and the power supply must have a grounding wire.
(2) Installation ensures that the power is turned off and the input voltage is between 180-220V 50Hz.
(3) If there is only one section of the power cord, the power cord must be led out to a certain length. The distance between the two holes is the length of the hanger.
(4) Prepare installation tools such as tape measure, marker and electric drill.
2. Measure the position and drill holes with an electric drill
Then measure the installation position. First measure the length of the smart electric clothes drying rack. Determine the installation positions of the fixings at both ends based on the length of the smart electric clothes drying rack. Then measure the width of the balcony and mark it. The middle of the cross is the installation position of the fixings. Then punch holes at the marked locations.
3. Installation of fixings
Assemble the fixings and expansion screws, and then use an electric drill to install the fixings on both sides.
4. Installation of smart electric clothes hanger box
There is a rectangular interface on both sides of the smart electric clothes drying rack box that is connected to the fixture. Clamp the two interfaces, install clamps on both sides, and then use screws to fix the clothes drying rack box on the clamp door.
5. Install the bracket group
For the fixing bolts used in the bracket, directly use the fixing bolts to connect and fix the folding arm. On the other side, fix the fixing bolts on the connecting holes of the folding arms. After installing the fixing bolts, pass the wire rope through the hanging bolt hole. Then tighten it with the hanging bolt screw. Do the same on the other side, pass the wire rope through the hanging bolt hole, and then tighten it with the hanging bolt screw.
6. Connect the power supply
When connecting the power supply, be careful not to make the wrong connection. Generally, when the power supply is successfully connected, the clothes drying rack will make a beeping sound to indicate a successful connection.
7. Connect the drying pole
First, you need to assemble the drying rod accessories. Put the drying rod into the half-open rings at both ends of the lifting frame. After the drying rod is placed into the rings at both ends of the lifting frame, use pipe clamps to clamp the drying rod and install the pipe clamp screws.
8. Adjust the drying rod
Use a tape measure to adjust the distance between the four corners and keep the lifting frame vertical to facilitate lifting and lowering. After adjustment, tighten the screws and finally trim the excess wire rope.

Send Inquiry
Send Inquiry